Water Heater Repair: Types, Common Issues, and Maintenance Tips
Water heater repair can be of three types:
hydraulic routine maintenance intervention
hydraulic over haul with cleaning and washing
hydraulic repair or replacement of hydraulic components
Common Gas Water Heater Issues
1. No Gas Flow
Check for gas, with the valves positioned parallel to the gas flow in the pipe (without disconnecting anything, if the situation exists). If the yellow knob (yellow must be standard) is perpendicular to the gas flow, the valve is closed; unless tampering or deterioration of the materials is present.
2.Air bubbles in the gas unit
Sometimes work is carried out in condominiums, and when the gas is restored, air bubbles can form. These disappear over time and after several attempts to restart the water heater repair. Otherwise, cracks may appear on the gas unit membrane, or the spark electrodes may be damaged or oxidized.
3.Electronic ignition batteries are flat
It’s a good idea to check the batteries under the boiler, as with the heating thermostat. They may run out every 3-5 years, depending on usage and how often the water heater is turned on.
4.Gas Water Heater: Burner Does Not Start
When the main flame fails to ignite, despite a functioning spark or pilot light, it could be due to several causes, including:
– insufficient water passing through the water heater repair ;
– oxidized ignition thermocouple, too far from the burner, or damaged;
– gas assembly malfunctioning due to failure to recognize the valve opening or a dirty/broken gas diaphragm
– poor exhaust gas evacuation
For internal parts such as the gas assembly, coil, burner, circuit board, etc., it is necessary to call an Authorized Service Center, preferably of the same brand as the appliance, given the specific nature of disassembling and dismembering internal parts to replace components.
5.Low Pressure
Very often, low pressure and therefore low water flow can prevent the boiler from recognizing the start command. An expert inspection and, possibly, a system cleaning are recommended.
6.Poor flue draft
If the water heater turns on but only lasts a few seconds and then shuts down, it may be due to a flue gas evacuation problem, which is blocking combustion. This is due to the increasingly delicate and precise control of the probes and safety systems in gas water heaters.
Water Heater Cleaning and Maintenance
When condensation somehow backs up from outside or rain onto the control board, a short circuit occurs, shutting down the boiler. Over time, the circuit board itself may not turn on, causing the boiler to fail due to oxidation.
A leak in the coil could significantly impact the electrical system of the appliance, though not necessarily immediately, as it will always start higher than the electrical system.A water heater repair service technician can periodically check the condition of the water heater, the coil, and all its components, which can prove very beneficial over time!
On-site water heater cleaning and maintenance
In the case of an inspection with burner cleaning and coil flushing, the plumber will work on-site with an electric pump connected to the installed water heater (still suspended), allowing the cleaning fluid to circulate for a specified period. This period generally ranges from 15 to 60 minutes and varies greatly depending on the amount of dirt present and the capacity of the coil. Depending on the calibration of the solvent dissolved in the water, a short, medium, or long flush will be performed.
Why perform an inspection + cleaning? Service + flushing
Advantages
This method has the advantage of being quick and more effective when performed in conjunction with a periodic inspection, as two interventions will be performed at a single price or in a single visit.Boiler Coil Cleaning.
Disadvantages
They are readily identifiable by both the plumber and the customer. The presence of a greenish color and visible external limescale deposits inside the boiler casing makes cleaning the coil risky, as the solvent used for descaling or pickling, if used incorrectly, could create micro or macro leaks in already vulnerable areas.
Furthermore, if the plumber inserts the cleaning fluid into the coil and fails to notice the presence of micro leaks (perhaps internal and imperceptible), the fluid could leak when reconnected and tested, due to the expansion of the micro leak.
Call 01163930338 now for a quick and professional service in Leicester !
The technicians we collaborate with:
Local Service 24h Emergency Services 24h